Subsystem Selection Guide
Printer Selection Guide
A Basic Ink-Jet Setup
Ink Jet Microdispenser
Printing Science:Principles and Practice
written by Prof. Steven Abbott contains background information on coatings in general and some ink-jet specific information. Associated with the book are several apps related to drop formation (
Ohnesorge for Inkjet
), line formation (
) and drop spreading (
Drop Spread Modeller
) that are based on published literature.
NIST paper on Inkjet Metrology:
High-Accuracy Mass Measurements of Microdroplets Produced by a Drop-on-Demand Dispenser
occurrence and approaches to eliminate them, September 2007.
PH-41H temperature response.
Small droplet Generation
(firmware version 6.3) supports up to 12-point control signal waveforms and therefore provides a huge variety of possible waveform configurations for different setups. November 2006.
Comparison of Drop Size when Dispensing MilliQ Water using 40um and 60um Orifice Diameter MJ Dispensing Device
. November 2006
Thermal characterization of Jetlab II
. November 2006.
Accuracy Survey of a Jetlab 4 system
. August 2008.
Accuracy Survey of a Jetlab 4 XLA system
. April 2010.
Technote 99-01: Background on Ink-Jet Technology
Technote 99-02: Fluid Properties Effects
Technote 99-03: Drive Waveform Effects
Technote 99-04: Orifice Diameter Effects
Technote 99-05: Performance of Four Fluids
Go to Top