MJ-A style drop-on-demand single jet dispensing devices are suited for dispensing droplets of aqueous and solvent-based fluids at up to 50°C. An integrated orifice and wetted surfaces that are almost exclusively glass make MJ-A devices extremely robust to aggressive fluids. Orifice diameters of 20-80um are available, allowing customers to optimize their process by selecting drop volumes within a two order of magnitude range. Fluids with viscosity less than 20 cPs and surface tension in the range 20-70 dynes/cm can be dispensed.
Three fluid fitting styles are available: barbed, threaded, and Luer. The threaded fitting is intended for use with PTFE tubing. The Luer fitting contains an integrated, removable filter.
The integrated orifice extends from the housing, allowing visualization of both internal flow and drop formation. The orifice can optionally be protected from damage by metal extensions on two sides.
Custom, application-specific configurations can also be developed.
Low-temperature dispensing device with barb fluid fitting, xxx denotes orifice diameter in microns. MJ-ABL (large) for 80-120 um orifice diameters.
Low-temperature dispensing device with barb fluid fitting & protected tip, xxx denotes orifice diameter in microns.
[alt] Low-temperature dispensing device with MINSTAC threaded fluid fitting, xxx denotes orifice diameter in microns.
Low-temperature dispensing device with MINSTAC threaded fluid fitting & protected tip, xxx denotes orifice diameter in microns.
Tubing assembly for AT and ATP devices: Minstac union, 20cm length of Teflon tubing (0.75mm ID, 1.5mm OD), Minstac to Luer adapter.
Low-temperature device with Luer fluid fitting, xxx denotes orifice diameter in microns. Includes 5 um sintered stainless steel filter element.
Diamond-Like Carbon coating on front face of orifice. Add –DLC designation to any MJ part number.
CT-M5-01: JetDrive™ V controller
CT-PT-21: Pressure / Thermal Controller
CT-PT-A1: Electronic Pressure Controller
CM-VS-03: Basic Optics System
Printhead Assemblies & Misc.: PH-03, PH-43, PH-46, PH 47, PH-41; tubing assemblies, reservoirs, in-line filters; cleaning & retesting service
|Standard orifice diameters
||20-80 um, 5 um intervals;
80-120 um for MJ-ABL
|Standard orifice diam. tolerance
||For 1 mm ID tubing
||MINSTAC, 0.138-40 UNF 2A, 5 turns
|MJ-AL, o-rings for filter
||EPDM, Buna, or Viton
||5 um sintered stainless steel
||Molex 50-57-9402; Molex 16-02-0097
|Standard wire length
|Printheads for MJ-AB, MJ-ABP
|Printheads for MJ-AT, MJ-ATP
||PH-46, PH-47, PH-43
|Printhead for MJ-AL
||< 20 cPs
|Fluid surface tension
||alcohols, ketones, aliphatics, aromatics, dipolar solvents
||nucleic acids, proteins, cells
||amino acids, lipids, biodegradable polymers
||fluxes, photoresists, epoxies, polyimides, electroactive polymers, cyanoacrylates, organometallics
||pigments, latex spheres, metal nanoparticles, teflon, phosphors, ferrites, zeolites
||sol-gels, thermoplastics, thermosets, acrylics, >1M salt solutions, photographic developer, fuels, aqueous adhesives, odorants
Drawings with dimensions
Equipment Selection Guide
A Basic Ink-Jet Setup
Go to Top